25mW 5.8GHz A/V Transmitter

25mW 5.8GHz A/V Transmitter

25mW 5.8GHz A/V Transmitter

Retail Price: $49.99

Compact, Lightweight, Compatible…

Now smaller!  The same size as the 600mW TX shown in the picture!

Comply
European RTT&E regulations place a limit of 25mW on 5.8GHz video transmitters. The 25mW version of this compact transmitter complies with these regulations.

Compatible
FPV flight was hampered in its early years by the rapid spread of 2.4GHz R/C gear. This equipment caused interference on 2.4GHz A/V links which made them unusable.

Quality
The higher video bandwidth, when compared with 2.4GHz systems, provides a high quality video image.

Switcher
The onboard switching regulator easily powers connected 5v cameras with a clean, noise-free power source, with enough power to drive power-hungry HD cameras.

Connectivity
The standard, polarized, locking FatShark/ImmersionRC connectors ensure that critical connections cannot work free during flight, and can never be inserted backwards.
 

  • 25mW output power
  • 25mW can be used license-free in Europe
  • SMA Antenna Connector (wire antenna on certain models)
  • Frequencies: 5740, 5760, 5780, 5800, 5820, 5840, 5860MHz
  • Not affected by 2.4GHz R/C radios!
  • Onboard quiet switching regulator, powers 5v cameras (including HD versions)
  • Weight: 20 grams
  • Size: 57 x 34mm
  • Input voltage range: 6 - 16 v
  • Input power: 1W (25mW), 1.5W (100mW)
  • May require a license to operate, Check local regulations before use

------------------------------------------------------------------------------

Notice: The use and operation of this product in the USA and many other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them.  ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.

--------------------------------------------------------------------------------

  • Model: IRC5.8-25MW
  • Shipping Weight: 0.25
  • -4 Units in Stock
  • Manufactured by: ImmersionRC


To be notified when this product is back in stock please click here.



Customers who bought this product also purchased...

GoPro Multifunctional Cable by Kristaps

GoPro Multifunctional Cable by Kristaps

Price:   $24.99
GoPro Multifunctional cable This cable is designed for GoPro HD HERO, HERO 2 and HERO 3* cameras. It plugs in to GoPro 30pin bus connector on back of...
GoPro Multifunctional Cable by Kristaps

Barometric Altitude and Temperature Sensor for DragonOSD+V2

Barometric Altitude and Temperature Sensor for DragonOSD+V2

Price:   $19.99
A super tiny barometric altitude and temperature sensor for the DragonOSD.  Features direct plug in to the I2C connector, and has a header...
Barometric Altitude and Temperature Sensor for DragonOSD+V2

3 meter (9.8ft) 3.5mm/3.5mm Video Cable

3 meter (9.8ft) 3.5mm/3.5mm Video Cable

Price:   $12.99
This is a 3 meter video cable compatible with FatShark goggles and ImmersionRC equipment that use a 3.5mm audio/video connector.  Longer than...
3 meter (9.8ft) 3.5mm/3.5mm Video Cable

HERO3 Anti-Fog Inserts

HERO3 Anti-Fog Inserts

Price:   $14.99
Drop inserts into sides of camera housing to prevent fogging in cold and humid environments. To Reuse: Inserts will last for approximately 4 uses. To...
HERO3 Anti-Fog Inserts

PowerBoxAV Audio Video and Power Distribution Box

PowerBoxAV Audio Video and Power Distribution Box

Price:   $49.99
Ground-station Companion Today’s ground-station is typically an array of devices, LCD monitors, LCD goggles, video recording devices, antenna...
PowerBoxAV Audio Video and Power Distribution Box

Filtered Balance Lead Power Supply Adapter

Filtered Balance Lead Power Supply Adapter

Price:   $9.99
Filtered power supply power adapter for FatShark and ImmersionRC transmitters.  Will supply power from a JST-XH  style 2s-3s balance...
Filtered Balance Lead Power Supply Adapter

Let us notify you when this product is back in stock!

Simply enter your details below and we will send you an e-mail when “25mW 5.8GHz A/V Transmitter” is back in stock!

We will not send you any other e-mails or add you to our newsletter, you will only be e-mailed about this product!