Hobbywing Flyfun 30A Brushless Speed Controller

Hobbywing Flyfun 30A Brushless Speed Controller

Hobbywing Flyfun 30A Brushless Speed Controller

Retail Price: $21.95

1 Specification

1.1 Output: Continuous 30A, Burst 40A up to 10 Secs.
1.2 Input Voltage: 2-4 cells lithium battery or 5-12 cells NiCd/NIMh battery.
1.3 BEC: 2A / 5V (Linear mode).
1.4 Max Speed: 210,000rpm for 2 Poles BLM, 70,000rpm for 6 poles BLM, 35,000rpm for 12 poles BLM.
(BLM: BrushLess Motor)
1.5 Size: 45mm (L) * 24mm (W) * 11mm (H).
1.6 Weight: 25g.

2 Features

2.1 Safety Arming Feature: Regardless the throttle stick position, the motor will not spin after battery connected.
2.2 Throttle Calibration: Throttle range can be configured to provide best throttle linearity, fully compatible with all market available transmitters.
2.3 Programmable Items:
Brake Setting: brake enabled / brake disabled.
Battery Type: Li-xx(Li-ion or LiPo) / Ni-xx(NiMh or NiCd).
Low Voltage Protection Mode(Cutoff Mode): Gradually reduce the output power / Cutoff the output power.
Low Voltage Cutoff Protection Threshold (Cutoff Threshold): low / medium / high.
Start Mode: normal / soft / very soft.
Timing: low / medium / high.
Reset: reset all the programmable items to their default settings.
2.4 Full Protection Features: Low voltage cutoff protection / Over-heat protection / Throttle signal lost protection.

3 Advantages

3.1 Military standard capacitor of extreme low resistance increases the ability of prevention of unwanted RF noise during flying.
3.2 Extreme low resistance PCB is helpful for getting a super current endurance capability.
3.3 Microprocessor uses separate voltage regulator IC, with good anti-jamming capability.
3.4 Compatible with Hobbywing's Program Card

  • Model: HW-FF30A
  • Shipping Weight: 0.15
  • 0 Units in Stock
  • Manufactured by or for: Hobbywing


To be notified when this product is back in stock please click here.



Customers who bought this product also purchased...

Camera Cable (3-wire)

Camera Cable (3-wire)

Price:   $6.99
This is a 3-wire camera lead compatible with many different common FPV cameras.  The wiring order on the camera connector as delivered will fit...
Camera Cable (3-wire)

RMRC Non-Slip Silicone Battery Strap - 20mm x 300mm (2PCS)

RMRC Non-Slip Silicone Battery Strap - 20mm x 300mm (2PCS)

Price:   $3.99
RMRC Battery Straps! 300mm total in length including buckle 20mm wide Allows for tight and secure battery mounting Includes silicone,...
RMRC Non-Slip Silicone Battery Strap - 20mm x 300mm (2PCS)

VAS - 1.3/2.4GHz Notch Filter

VAS - 1.3/2.4GHz Notch Filter

Price:   $9.99
Notch filter from IBCrazy.  Use this on your 1.2-1.3GHz video transmitter to filter out interference in the 2.4GHz spectrum. New Compact Design.
VAS - 1.3/2.4GHz Notch Filter

APC 7x6E Prop

APC 7x6E Prop

Price:   $2.39
APC 7x6E Prop

Camera Cable (4-Wire Super Compact to ImmersionRC/FatShark)

Camera Cable (4-Wire Super Compact to ImmersionRC/FatShark)

Price:   $6.99
This is a super small 4-wire camera lead compatible with many different common FPV cameras.  Will plug directly in to FatShark or ImmersionRC...
Camera Cable (4-Wire Super Compact to ImmersionRC/FatShark)

Transmitter Cable (Mini)

Transmitter Cable (Mini)

Price:   $9.99
This is a 4-wire camera lead compatible with many different common FPV transmitters, most notably the 100mW and 300mW 1.3GHz and the 500mW 900MHz...
Transmitter Cable (Mini)

Let us notify you when this product is back in stock!

Simply enter your details below and we will send you an e-mail when “Hobbywing Flyfun 30A Brushless Speed Controller” is back in stock!

We will not send you any other e-mails or add you to our newsletter, you will only be e-mailed about this product!