Pixhawk Mini Micro M8N PM06 Micro Telemetry (915Mhz)
by Holybro

The 3DR Pixhawk Mini autopilot is a next-generation evolution of the Pixhawk. It is about 1/3rd the size of the original Pixhawk and has more powerful processors and sensors for ultimate flight control. The Pixhawk Mini is based on the PX4 open-hardware project and has been optimized for the PX4 flight stack and is one of the most advanced autopilot systems on the market toady! Get yours today!

Changes made from the orginal PixHawk Mini

• Smaller, a third of the size.
• Rev 3 processor for long term software support.
• Improved sensors, both primary and secondary IMU MPU9250 and ICM20608 for more reliable flight.
• Included GPS module uBlox M8N GPS/GLONASS/BeiDou receiver for faster and stronger GPS lock.
• Micro JST rather than the hard-to-use DF13 connectors.
• Integrated piezo speaker and safety switch.
• Natively supports 4S batteries with the included PDB.
• No longer includes OSD 

Features

• Advanced 32 bit ARM Cortex® M4 Processor running NuttX RTOS
• 8 PWM/servo outputs
• Abundant connectivity options for additional peripherals (UART, I2C, CAN)
• Redundant power supply inputs and automatic failover
• Integrated safety switch and optional external safety button for easy motor activation
• Multicolor LED indicator
• Integrated multi-tone piezo audio indicator
• microSD card for long-time high-rate logging

GPS Module Information:

• Based on the uBlox M8N
• Concurrent reception of up to 3 GNSS (GPS, Galileo, GLONASS, BeiDou)
• Industry leading –167 dBm navigation sensitivity
• Security and integrity protection
• Supports all satellite augmentation systems
• Advanced jamming and spoofing detection
• Product variants to meet performance and cost requirements
   

Includes:

• 1X Pixhawk Mini Autopilot Flight Controller (915Mhz)
• 1X GPS module
• 1X Quad Power Distribution Board
• 1X 8 Channel PWM Breakout board
• 1X 4 pin i2c cable and breakout board
• 1X RC-in cable for PPM/SBUS
• 1X 6 to 6/4 ‘Y’ adapter for GPS and additional I2C devices
• 2X 6 pin cable
• 1X 6 pin JST to DF13 for legacy telemetry radio
• 1X External safety switch
• 1X 8 channel PWM breakout cable
• 1X Mounting foam