STRIX NoctuaGlow LED Dimmer/Switch - PWM Controlled
by STRIX

The STRIX NoctuaGlow LED Dimmer/Switch is a high-capacity, PWM-controlled power management module designed specifically for the STRIX NoctuaGlow LED system. This versatile controller allows pilots to integrate their aircraft's night-flying aesthetics directly into their radio system, providing seamless transition between full-intensity illumination and total darkness. Whether you are performing a tactical "disappearing act" in the night sky or need to reduce the "halo effect" after too many adult beverages, this module offers granular control over your LED brightness via any standard PWM receiver channel.

Engineered for the professional night-ops RC pilot, the NoctuaGlow Dimmer supports a massive 14A maximum current, allowing it to power extensive LED arrays without overheating. Its wide 5-30V passthrough range ensures compatibility with everything from small 2S park flyers to high-voltage 6S platforms. By pairing the module with a slider or knob on your transmitter, you can dial in the exact lumen output required for the ambient light conditions, ensuring optimal visibility without blinding the operator or fellow pilots.

Specifications

• Control Protocol: PWM (Standard Receiver Channel)

• Input Voltage: 5V – 30V (Passthrough)

• Maximum Current: 14A

• Connectivity: JST Female (Power In) / JST Male (Power Out)

• PWM Interface: Standard 3-pin JR-style connector

• Wire Length: 10cm

• Board Dimensions: 22mm x 12mm

• Total Weight: 6g (including wires)

• Functions: Dimming (via Slider/Knob) or On-Off (via Toggle Switch)

What is Included

• 1x STRIX NoctuaGlow LED Dimmer/Switch Board

• Integrated Power and PWM Wiring Harness

• Transparent Protective Heat Shrink (Pre-installed)