Holybro PM02D Power Module (2s-12S)
by Holybro

The Holybro PM02D Power Module (2S-12S HV) is a high-performance digital power solution designed for advanced flight controllers such as the Pixhawk 5X and 6X series. Unlike traditional analog power modules, the PM02D utilizes a digital I2C interface (via the TI INA226/INA228 IC) to deliver highly accurate battery voltage and current consumption data directly to the autopilot. This version is the High Voltage (HV) variant, supporting a wide input range from 2S to 12S LiPo batteries, making it suitable for everything from agile 5-inch drones to large-scale industrial sUAS.

Equipped with a high-efficiency switching regulator, the module provides a stabilized 5.2V output at up to 3A to power the flight controller and essential peripherals like GPS and telemetry radios. The unit comes pre-assembled with XT60 connectors and 14 AWG silicone wires, wrapped in protective heat shrink for field durability. It is a critical component for pilots requiring precise telemetry and reliable power redundancy in professional or research-oriented autonomous vehicle builds.

Specifications

• Model: PM02D (High Voltage Version)

• Input Voltage: 2S – 12S LiPo (Max 60V)

• PCB Continuous Current: 60A

• PCB Burst Current: 100A (<60 sec)

• Max Current Sensing: 327A

• Communication Protocol: Digital I2C (INA226/INA228)

• Regulator Output: 5.2V @ 3A Max

• Main Connectors: XT60 (Pre-soldered)

• Wire Gauge: 14 AWG Silicone Wire

• Interface Connector: 6-pin 2.00mm pitch CLIK-Mate

• Dimensions: 25 x 25 x 10 mm

• Weight: 20g

• Firmware Support: PX4 & ArduPilot (v4.4 or later required for HV)

What is Included

• 1x Holybro PM02D Power Module (2S-12S HV)

• 1x 6-pin 2.00mm Pitch CLIK-Mate Cable (for Pixhawk 5X/6X)

Important Compatibility Note: This is a digital power module and is not compatible with flight controllers that require an analog power signal, such as the Pixhawk 6C, Pixhawk 4, or Durandal. It is purpose-built for the Pixhawk 5X and 6X series.