The RFDesign RFD900ux/868ux Antenna Cable (u.FL to RP-SMA) (MPN: CABLE-RFD900u-Antenna) is a 150mm coaxial RF adapter pigtail engineered to connect full-size RP-SMA telemetry antennas to the micro u.FL (IPX/IPEX) antenna ports on RFDesign RFD900u, RFD900ux, and RFD868ux long-range radio modems. By converting delicate surface-mount u.FL receptacles into a chassis-mountable RP-SMA female bulkhead interface, this cable relieves mechanical strain from the modem PCB and enables clean external antenna routing through carbon fiber airframe plates or ground station enclosures.
Constructed with 50-ohm impedance-matched micro-coaxial cable and gold-plated connectors, the pigtail weighs 4.3 grams and spans 150 mm (~6 inches), offering flexible routing from deep inside UAV avionics bays to external antenna mounts without degrading long-range 868MHz or 900MHz RF signal integrity. Because the RFD900ux and RFD868ux modems utilize dual u.FL ports for automatic antenna diversity, two adapter cables are used when equipping a modem with dual external RP-SMA antennas.
u.FL (IPX) to RP-SMA Female Conversion: Adapts board-level u.FL/IPEX receptacles on RFD900u, RFD900ux, and RFD868ux modems to a standard Reverse-Polarity SMA (RP-SMA) female interface for high-gain 868MHz/900MHz dipole and directional antennas.
Threaded Bulkhead Chassis Mount: Equipped with a threaded RP-SMA bulkhead barrel, hex nut, and lock washer for rigid, vibration-resistant mounting directly through drone airframe plates or ground station housings.
50-Ohm Matched Impedance & Plated Contacts: Maintains low insertion loss and reliable RF conductivity across 865–928MHz long-range telemetry links.
Flexible 150mm Routing Length & 4.3g Weight: Provides approximately 6 inches of routing reach inside tight fuselage bays while adding minimal weight to airborne platforms.
Product Type: Coaxial RF Adapter Pigtail / Bulkhead Extension Cable
Connector A (Modem Side): u.FL / IPX / IPEX Female Plug
Connector B (Antenna Side): RP-SMA Female Bulkhead Jack (with center pin)
Nominal Impedance: 50-ohm
Cable Length: 150 mm (~5.9 inches)
Net Weight: 4.3 grams
Modem Compatibility: RFDesign RFD900u, RFD900ux, RFD868ux, and standard 50-ohm u.FL RF modules (868MHz / 900MHz / 915MHz)
(1) RFDesign RFD900u/ux Antenna Adapter Cable (u.FL to RP-SMA Female Bulkhead, 150mm)
(1) Bulkhead Hex Retaining Nut and Washer
| Name | Value |
|---|---|
| MANUFACTURER | RFDesign |
You can also contact us at support@readymaderc.com.
Or give us a call at +1(740)-936-4500.