An audio/video cable for the GoPro HERO3, HERO3+, and HERO4 cameras using the USB Audio/Video live out port. On one side, a right angled USB connector linked to a super flexible servo cable, and on the other end an ImmersionRC/FatShark compatible plug. A total length of 8 inches (20cm), weighing only 4g
***Not compatible with the HERO and HERO2 cameras and the Fatshark FCC approved vtx type
Easily connects directly to your ImmersionRC and FatShark gear, and can charge the HERO3 battery from the power source!* **
*FLIR cameras need a 500-750mA 5v power supply, Immersion and Fat Shark transmitters do NOT supply enough power to successfully run the camera. A separate 5v power source is needed.
Live video output quality varies between the various video modes and between the different versions of the HERO3 cameras. We've found that with the Silver version, the only mode that outputs smooth video with little delay is 720p/60. All other modes have noticable delay and low frame rate. We'll update with more information as we get more information for the White and Black version.
*Charging/Powering function should only be used on transmitters with switching regulators, and requires airflow over transmitter to prevent over heating. Red wire should be cut and capped if your transmitter does not use a switch mode regulator.
** Zenmuse H3-2D users should remove the red pin on the 5 pin connector as the H3 supplies power to the camera.
Limit of 100 pcs per order. If multiple orders are placed, we may hold some orders if our stock levels are becoming too low.