Surface 120 FPV Racer Frame kits are CNC machined from billet aluminum. These multirotor frame kits are very strong, light weight and look great. They will work with a variety of brushless motors running on 2S, 3S, and even 4S.
Assembly is very straight forward with only a few pieces. Kits can be put together in the traditional layout with the motors on the bottom frame allowing up to 2.25" (57mm) props. Or they can be configured as an underslung design with the motors on the top platform allowing for 3" (76mm) props. All parts are included for either setup.
These will accommodate a full FPV setup with separate logic board, ESC's, BEC, and RX. See our recommended components below.
The aluminum frame kits offer advantages such as a rigid platform for responsive flying, arms acting as heat sinks keeping the motors running cooler, and the attention to detail not normally found on these smaller quads.
Below are a few links with a full build video, Libre Pilot setup sheet, and a great flying video showing what these can do.
Included: 1 - Surface 120 FPV Racer Frame Kit
Weight (complete frame with landing gear and screws): 29g
All up flying weight can vary depending on how kit is assembled. We have assembled these with full FPV gear on 3S battery having an all up weight of around 115g. No FAA regulations on this quad!
- Motor Spacing (front left corner to rear right corner): 120mm
- Spacing between top and bottom platform: 14mm (.550")
- Short Landing Gear: 11.5mm (.450")
- Long Landing Gear: 21.5mm (.850")
- Motor Bolt Pattern: 8.4mm to 10mm with 2mm screws