3DR "Stick" Carrier Board for Control Zero H7 OEM G
by 3DR

The 3DR "Stick" Adapter Carrier Board (Model M10062B) is a highly specialized, ultra-slim expansion platform designed exclusively for the Control Zero H7 OEM (Revision G) flight controller. Engineered to meet the demanding spatial constraints of narrow fixed-wing fuselages, compact multirotor frames, autonomous rovers, and streamlined marine robotics, this carrier board slims down the footprint of your core avionics stack without compromising processing capability. By converting the high-density Samtec micro-interconnect system of the Control Zero module into industry-standard peripheral breakouts, the Stick carrier provides an integrated, robust architecture for commercial and industrial unmanned systems.

To achieve its ultra-narrow 21.6 mm width, the board features an optimized layout that condenses peripheral connectivity down to the most critical flight ecosystems. It exposes dedicated JST-GH lockable ports for universal plug-and-play interfacing with GPS systems, TELEM1, TELEM2, primary system power, and dual independent CAN bus nodes configured for DroneCAN peripherals. Additionally, it preserves standard 0.1-inch through-hole pin headers for clean, high-density PWM servo and ESC signal output routing. This deliberate architecture balances industrial-grade connectivity with a minimal profile, allowing enterprise developers to seamlessly drop high-performance H7 processing into severely space-restricted autonomous hulls.

Technical Specifications

• Compatible Autopilot Core: Control Zero H7 OEM / Control Zero OEM Series (Revision G Optimized)

• Form Factor Variant: Ultra-Narrow "Stick" Profile Adapter

• Primary Interconnect Interface: High-density sockets

• Peripheral Breakout Interfaces: JST-GH Lockhart Connector Standards

• Supported Onboard Serial Ports: TELEM1, TELEM2, and Dedicated GPS + I2C Ports

• Bus Architecture Support: 2x Independent CAN Bus Channels (Pre-configured for DroneCAN)

• Actuator/Servo Outputs: 0.1-inch Through-Hole Pin Headers for up to 8x PWM Channels

• Onboard Configuration/Debug Port: Micro USB Interface

• Physical Module Width: 21.6 mm (0.85 inches)

• Physical Module Length: 81.5 mm (3.21 inches)

• Physical Module Thickness: 4.81 mm (0.19 inches)

• Mounting Hole Spacing Layout: 65.6 mm x 15.6 mm (2.58 in x 0.61 in) Center-to-Center

• Mounting Hole Structural Size: 2.6 mm Diameter (Direct fit for M2.5 hardware fasteners)

• Net Hardware Weight: 4.7 grams (Dry board without pin headers) / 6.5 grams (With pre-installed pin headers)

• Logic Level Architecture: Full 3.3V System Logic with ESD and current-limiting circuit protection

What's Included

• 1 x 3DR "Stick" Carrier Board (Model M10062B) for Control Zero H7 OEM