Holybro - PM06 V2 Power Module 14S Version
by Holybro

The Holybro PM06 V2 Power Module (14S Version) is a compact, dual-purpose power management solution engineered specifically for small-to-medium autonomous aircraft, FPV platforms, and commercial sUAS builds. This indispensable component fulfills two critical roles simultaneously: it acts as an integrated Power Distribution Board (PDB) capable of routing battery power to up to four electronic speed controllers (ESCs), while housing an on-board switching regulator that steps down raw battery voltage to supply a clean, filtered 5.2V power rail to your autopilot.

Tailored for high-voltage flight configurations, the 14S version accepts a massive input voltage range from 2S up to 14S LiPo batteries. The on-board analog telemetry circuitry accurately samples battery voltage and real-time current consumption, translating this critical data into standard analog signals that feed directly into your autopilot via a 6-pin JST-GH cable. This allows ground control stations (such as Mission Planner or QGroundControl) to display real-time fuel gauges, calculate remaining flight times, and trigger low-battery failsafes. The board comes completely assembled with a pre-soldered 220µF 63V electrolytic capacitor to soak up destructive ESC voltage spikes and includes a pre-installed XT60 connection lead.

Compatibility & Setup Note: The PM06 V2 outputs analog telemetry data and is natively compatible with analog-sensing flight controllers such as the Pixhawk 4, Pixhawk 4 Mini, Pixhawk 6C, Pixhawk 6C Mini, Pix32, and Durandal. It is not compatible with the Pixhawk 5X or 6X architectures, which require a digital I2C module (like the PM06D). Additionally, while the internal PCB is rated for a 70A continuous load, the pre-soldered 12AWG wire and XT60 plugs are rated for 30A continuous / 60A burst. If your build surpasses 30A continuous current draw, the wire gauge and plug type must be updated accordingly.

Technical Specifications

• Product Model: PM06 V2 Power Module (14S High-Voltage Version)

• Input Voltage Spectrum: 2S to 14S LiPo (Max 60V+)

• PCB Continuous Current Rating: 70A

• PCB Burst Current Rating: 120A (For durations < 60 seconds)

• Regulated UBEC Output Voltage: 5.2V DC

• Maximum UBEC Output Current: 3A Maximum (18W Max Power)

• Thermal Output Restriction: UBEC output should be limited to < 2A when running maximum 14S packs to ensure proper heat dissipation.

• Telemetry Output Signal Type: Analog Voltage & Current Sensing

• ArduPilot/PX4 Calibration Parameters: Voltage Divider: 18.182 | Amperes per Volt: 36.364

• Pre-soldered Wire & Plug Spec: 12AWG Silicone Wire with XT60 Male Connector (Rated for 30A Cont. / 60A Burst)

• Integrated Filtering Capacitor: 220µF 63V Electrolytic Capacitor

• Telemetry Connector Interface: 6-Pin JST-GHR 1.25mm Pitch

• Integrated ESC Distribution Pads: 4 Channels (Positive/Negative Pair Pads)

• Physical Mounting Dimensions: 35 mm x 35 mm x 5 mm

• Mounting Hole Grid Spacing: 30.5 mm x 30.5 mm Standard Pattern

• Net Hardware Weight: 24 grams

What's Included

• 1 x Holybro PM06 V2 Power Module (14S Version with pre-soldered XT60 lead and capacitor)

• 1 x JST-GHR 6-Pin to 6-Pin 1.25mm Pitch Telemetry Interconnect Cable